FILL-RITE 800 & 900 SERIES FLUID METERS
These FILL-RITE meters are low cost meters similar to those used on the popular FILL-RITE consumer pumps and are produced for a variety of liquids. These meters utilize a proven nutating disc design to provide low flow rate accuracy and can handle pressures to 50 psi and temperatures to 150° F. Meters are of aluminum construction with glass filled polyester metering chamber assembly. Meters are suitable for many liquids including gasoline and diesel fuel, liquid feed, solvents, anti-freeze, creosote and many industrial liquids. 800 Series: 5-20 GPM with accuracy to within ±1 %. Indicates to 100 gallons with 100,000 gallon totalizer. 900 Series: 6 to 40 GPM with accuracy to within ±2% Indicates to 1000 gallons with 10,000,000 gallon totalizer.
FILL-RITE 820 DIGITAL FLOW METER
The FILL-RITE 820 Digital Flow Meter Is built from rugged, corrosion resistant polypropylene and stainless steel for long service life. It meters bulk chemicals, herbicides and approved liquids with fingertip calibration. Unparalleled accuracy, durability, automatic data protection, easy use, easy Installation and low maintenance design are some of the features that make this meter a popular choice.
Features: Flow range 2-20 U.S. GPM, Glass filled polypropylene meter, Lathe cut Viton seals, Digital LCD display, 100 PSI, 1” NPT inlet/outlet ports. Power Source: 2-AA batteries.
Nutating disk design with precision machined bronze chamber for reliable measurement over a wide range of flows. Heat resistant disk plate, and graphite half balls minimize wear and insure sustained accuracy. Casing, gears and measuring chamber are composition bronze. Disk material is reinforced synthetic polymer.
3/4” Meter has capacity range of 3 to 30 GPM and 1” Meter has a range of 5 to 50 GPM. Register supplied is a 600 Series register with non resettable totalizer. Inquire about other registers.
5 Gallon test measure is carefully and accurately calibrated. Equipped with an easy to read gauge. Stainless Steel Construction. Used for calibrating meters and other liquid measuring devices. Plastic case available for safe storage of device.
¾” or 1” - B1 with strainer
Test measure (Meets National Standards)
Plastic Case to safely store test measure